OK, this isn't an actual question, more or less of how this problem was fixed. Going to post it for the benefit of others who might run into the same problem.
So, I had an event that Warped you to a spot in the same dungeon and then Event Transitioned over to another event. I could always get the character to warp, but couldn't get the transition to take effect (The character speaking). Upon looking at the manual, it says then any Event Code after Warp will not activate. So what to do..
Well I had used the Warp command previously and it had worked just fine and the reason why was because when the party warped to the next map, there was an auto event that kicked off and transitioned over to the character speaking.
So, I did the same thing, only placed the Auto event in the dungeon, added two modes to it and then right before the character warps, switched the Auto Event's mode to 2 so that it kicks off and transitions over to the character event.
Just thought this little bit of trickery might help someone out in case someone might be having a problem with Warps.
So, I had an event that Warped you to a spot in the same dungeon and then Event Transitioned over to another event. I could always get the character to warp, but couldn't get the transition to take effect (The character speaking). Upon looking at the manual, it says then any Event Code after Warp will not activate. So what to do..
Well I had used the Warp command previously and it had worked just fine and the reason why was because when the party warped to the next map, there was an auto event that kicked off and transitioned over to the character speaking.
So, I did the same thing, only placed the Auto event in the dungeon, added two modes to it and then right before the character warps, switched the Auto Event's mode to 2 so that it kicks off and transitions over to the character event.
Just thought this little bit of trickery might help someone out in case someone might be having a problem with Warps.
