Bridges

[Tmanerer]

how do you make bridges i mean how stupid is it not to have bridges in rpg3
and also what about waterfalls

i have an idea about bridges using the quarry stone and raise it so where
you can walk on it.
but can you walk on it

[Seraph]

Re: Bridges

No, I don't think you can walk on them. And waterfalls are a no go too.

[Pagerron]

Re: Bridges

You cannot walk on top of any decorative items, but the info in the link below at least looks like a bridge (still requires warps)

http://www.pavilionboards.com/forum/...&postcount=153
---------------------------------------------

If you really want to have a bridge that can be walked across(no warps needed), try this:

In the field editor, create the following -

XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX
XXXXXXXXXXX

X = grasslands (height 86)
X = rock (height 86)
X = water (height 0)

Then go to layout mode and select the outside decoration "lumber" Lower it to -0.95 height and line it up so that the highest log is just at the edge of the rock ground.

Line five of these up on each side of the bridge, to give it a defined edge.

Then, place four "stone tablets" lowered to -1.28 height at the ends of the bridge edges.

It comes out looking pretty good, and it can be walked across. Good luck with it, man.

[Seraph]

Re: Bridges

That's good stuff Pagerron. Thanks!